https://sfbay.craigslist.org/eby/cto/d/ ... 84384.html
15
1997 BMW M3
fuel: gas
odometer: 155000
title status: clean
transmission: manual
Up for sale is my pride and joy. It breaks my heart to sell this car and I'm constantly being harassed by my friends because of it.
Truth is, I bought a corvette and will be tracking that from now on.
Car is a 1997 BMW M3 that I bought in 2010. Since then I have spent countless hours and thousands of dollars getting this car to where it is now. Engine is original to the car but has been gone through extensively. Last Feb, car was victim of a cracked head. Replaced the head along with a few valves (receipt available for machine shop work).
Because I work at a race shop, the vehicle has always been properly maintained and taken care of. With that being said, I often did not record or get receipts for work performed mostly because I did the work myself and parts/fluids were on site in bulk.
Car is very competitive in time attack and only needs a few more safety items to compete in NASA/SCCA racing (weld in roll cage, fire suppression system etc...)
Car runs Sub 2 minute lap times at Sonoma, Thunderhill east, and Buttonwillow
Car is very fast and turns heads everywhere I go. Weighs in at 2750 lbs dry
Mods/features include:
-S52
-Miller WAR chip with tune ~274rwhp 240tq
-OBDI swap with chip and tune
-M50 Manifold
-OBDI PCV system including new valve cover
-Bosch Ford 24# injectors
-Stock reground cams (cheater cams)
-Dinan throttle body
-Full intake
-Ebay headers
-Catless 3" full exhaust with muffler. (passes sound at all local tracks except MRLS)
-Revshift poly engine and transmission mounts (green)
-Head replaced within the last 5 track days. Work done early 2017.
-Ireland Engineering strut bar
-Bimmerworld dual fuel pumps
-Mishimoto aluminum radiator
-Euro E30 coolant expansion tank
-Always used water with water wetter
-Electric fan with toggle switch
-Silicone radiator hoses
-External oil cooler
-Motion Motorsport underpanel and splitter with radiator baffle
-AJ Hartmann headlight intake duct
-Hard Motorsport V2 fender flares
-Apex ARC 8 18x10 wheels with Toyo R888R on all four corners (tires need replacement)
-AST 4100 Coilovers
-Ground Control camber/caster plates
-Wilwood dynapro brakes. 6 piston front, 4 piston rear.. Will include brand new set of H compound brake pads
-Front brakes are E46 M3 OEM rotors
-Carbon fiber hood and trunk
-APR GTC 200 carbon fiber wing with risers
- Mkah motorsport door panels and center console delete panel. Also have radio delete panel with holes for gauges
-AKG Short Shifter
-Sparco EVO fia approved race seat
-Bolt in cage
-OMP 6 point harness with anti submarine provisions
-OMP targa steering wheel (non removable)
-Carbon fiber sunroof delete panel
-Mateo Motorsport diffuser
-ACT lightweight steel flywheel (11lbs)
-Brand new oem clutch
-Trackspec hood vent
-Will include aerolatches
-Will include new stainless brake lines
Transmission fluid, brake fluid, diff fluid, all replaced within the last 6 months.